qdosmsq:pe:vectors:setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

qdosmsq:pe:vectors:setup [2009/01/30 10:50]
norman created
qdosmsq:pe:vectors:setup [2010/01/12 16:16] (current)
norman Register D0 used when it should be D1. Fixed.
Line 14: Line 14:
  
 None (D0 is always zero) None (D0 is always zero)
 +
 ==== Notes ==== ==== Notes ====
  
   *No other registers are used.   *No other registers are used.
-  *The size given in D1 will usually be that found from WM.FSIZE. When D0 is zero the default size is used. If D0 is -1 the size and position in the (existing) working definition will not be changed.+  *The size given in D1 will usually be that found from WM.FSIZE. When D1 is zero the default size is used. If D1 is -1 the size and position in the (existing) working definition will not be changed.
   *The working definition is set up without completion of application windows. If there is a standard menu this can be set up by supplying the standard routine " jmp WM.SMENU(a2)"​.   *The working definition is set up without completion of application windows. If there is a standard menu this can be set up by supplying the standard routine " jmp WM.SMENU(a2)"​.
   *The area to which A4 points will normally have been allocated from the common heap and must be large enough to contain the working definition. The size of that area will usually be supplied by the program (such as SETW) setting up the window definition.   *The area to which A4 points will normally have been allocated from the common heap and must be large enough to contain the working definition. The size of that area will usually be supplied by the program (such as SETW) setting up the window definition.
  • qdosmsq/pe/vectors/setup.1233312613.txt.gz
  • Last modified: 2009/01/30 10:50
  • by norman